Bob Latino at 20h27
08
Jun
2010
The little known Dynaco PAS-3 Series II - photo
Many know about the older Dynaco PAS-2 and PAS-3 preamps and the more modern mid '90's Dynaco PAS-4 built by Panor. There was, however, a transitional model built in the early '90's also by Panor > the PAS-3 Series II. The circuits of all three preamps were different. The tube line-up for each preamp was ...
PAS-2 and PAS-3 > four 12AX7 tubes
PAS-3 Se
Many know about the older Dynaco PAS-2 and PAS-3 preamps and the more modern mid '90's Dynaco PAS-4 built by Panor. There was, however, a transitional model built in the early '90's also by Panor > the PAS-3 Series II. The circuits of all three preamps were different. The tube line-up for each preamp was ...
PAS-2 and PAS-3 > four 12AX7 tubes
PAS-3 Se
About
This topic belongs to the forum
Free forum : Dedicated to the preservation, restoration and rebuilding of all Dynaco tube audio equipment.
- Numbers of topics : 1217
- Numbers of messages : 7795
- Numbers of users : 1127
- Numbers of points : 1323
Similar topics
Sorry to rant here but sometimes I see online what I would consider a "Dynaco abortion". This is (what appears to be) a stock Dynaco ST-70 with an older GSI driver board. Now there is nothing wrong with removing the stereo/mono switch or maybe even
This is an interesting looking custom built Dynaco ST-35 with a marble top that looks to be about 3/4 of an inch thick. I am glad that I wasn't the guy who had to drill the holes in the marble for the tube sockets. I never saw any tube amp with a marble
I have a Dynaco Pas 3 Series II pre-amp built by Sound Valves. Are there any other tubes recommended for this besides the supplied Sovtek's? This is a very good unit and I was looking to upgrade the tubes. Does anyone else have this pre-amp, or no someone
Turn out the lights and listen to the music ... Tube amps just look cool in darkness .. Something you can't get from a solid state amp..
VTA boarded Dynaco amp photo taken "by the light of the tubes .."
Bob
Hi, all
I had one ST-70 series II, but cannot adjustment bias from LOW up to HIGH LED light on.
Where / how to check which component(s) in circuit to solve it problem? Thanks!
Best regards,
Jackson
Forums from same category
audioenjoyment
Free forum : Science Fiction in Cinema, Books, Comics and everything
A tasteful online marketplace and forum to find wonderful deals for hi-fi audio & video equipment in Malaysia, Singapore & internationally, a haven for the Hi-Fi or AV enthusiast.
Search
Informations
5 Replies For the topic :
"The little known Dynaco PAS-3 Series II - photo"
This topic has been viewed 3316 times.
Last message :
08/06/2010 at 20h27 by "Bob Latino"






