REVIEW - Tubes4hifi SP-8SE tube preamp KIT

Bob Latino at 12h07
22
Sep
2009
REVIEW - Tubes4hifi SP-8SE tube preamp KIT

Roy Mottram, the designer of the VTA driver board and the SP-6, SP-8 preamps, was kind enough to ship me one of his wired and tested SP-8SE (Special Edition) "kit" preamps for evaluation. This preamp is 16 inches wide by 4 1/4 inches high and 12 inches deep and weighs in at a healthy 11 1/2 pounds. The preamp has four high level inputs and one phono level input. It has one t
About
This topic belongs to the forum
  • Numbers of topics : 1217
  • Numbers of messages : 7795
  • Numbers of users : 1127
  • Numbers of points : 1323
Similar topics
I am considering purchasing the SP-8 preamp kit but have a couple of questions. The resistors that come with the kit...are they metal or carbon film. I noticed that the upgrade resistor package says that it contains TAKMAN resistors but does not say if
I would be curious if anyone has one of the phono preamps and what their impression is of it. I need one in order to get my system back up and running. Thanks Mike
Brand new here and looking for feedback. I know no one will be able over the internet to evaluate my skills in building a PH 14 (actually thinking about the 15, I like Sonicaps). I can appreciate the tempered skepticism in answering my questions and can
Why is there no bass and treble control on some preamps like the SP-8?
After much thinking on wether to buy a used tube amp or build a kit amp I deceied to build a ST120 . The thinking was because I know little about electronics or sterio design . And I never have built anything like this before ! I now know a littl
Forums from same category
See also
more_less
Informations

5 Replies For the topic :
"REVIEW - Tubes4hifi SP-8SE tube preamp KIT"

This topic has been viewed 10000 times.

Last message :
22/09/2009 at 12h07 by "Bob Latino"