Fid at 01h05
08
Nov
2010
Reception on Vacuum tube car radios
Here's a question I have about a something that I see quite often. I repair a lot of old 6 and 12 volt car radios (tube type). Sometimes I'll have a radio that only picks up when I'm holding the antenna in my hand and it uses me as an auxillary antenna. I've checked the RF amp tube and circuits, swapped the tubes etc. I've tried different locations within my house, or usually I test it out in the garage where most models have great reception. But
Here's a question I have about a something that I see quite often. I repair a lot of old 6 and 12 volt car radios (tube type). Sometimes I'll have a radio that only picks up when I'm holding the antenna in my hand and it uses me as an auxillary antenna. I've checked the RF amp tube and circuits, swapped the tubes etc. I've tried different locations within my house, or usually I test it out in the garage where most models have great reception. But
About
This topic belongs to the forum
Tube Radio forum.Vintage Electrical Appliance
- Numbers of topics : 1161
- Numbers of messages : 6894
- Numbers of users : 698
- Numbers of points : 615
Similar topics
Working on a 1951 Zenith G615 that started out with only a hum. Changed two filter caps and got fair reception. Proceeded to change all other paper caps one at a time checked reception as I went. When finished had good clear crisp reception with no
Hi All:
I'm an advanced beginner, if that makes sense, with a Zenith J615 Chassis 6J05. It was completely dead on arrival. I replaced all the electrolytics and paper caps. All tubes were checked and are good. The radio will now tune in a few
I own a zenith royal 3000 no reception anyone have any awnsers
I know that the ARF has a section for tube audio but I don't post much there because I know that the main thrust is for radio. However, my main interest is late 50s to mid 60s tube audio. I also like Knight-Kit transistor amplifiers too. So, if you lik
I have a Heathkit A0-1 Audio Oscillator that my father built in the '50s, I replaced the caps and cleaned up the switch contacts and it seems to work ok except the sine wave shows some distortion on a scope. I am a beginner and have no idea about how to
Forums from same category
A form dedicated to making soaps and other bath and body products. We welcome all different levels of experience, and are willing to help others learn how to make these for yourself.
Free forum : Nerfing down under!. Oz Nerf - Australian Nerf Community
Free forum : PRA*ISE Promoting Reborn Artistry * Issued Standard of Excellence
Bilge
Free forum : Hello and Welcome to our PSP Forum. Here we have all kinds of fun games and psp related challenges. We hope to see you on the boards.
A Sports Autographs And Memorabilia Collectors Forum
Search
Informations
2 Replies For the topic :
"Reception on Vacuum tube car radios"
This topic has been viewed 633 times.
Last message :
08/11/2010 at 01h05 by "Fid"






