Heathkit TC-3 Tube Checker

mikhail7 at 15h17
12
Sep
2010
Heathkit TC-3 Tube Checker

I just accquired a Heathkit RC-3 tube checker, with assembley and use instructions, assembled. Anyone know if it's good, bad, so-so? I picked up a Philco tube tester in Lansing last July but it checks only continuity.

Mike
About
This topic belongs to the forum
  • Numbers of topics : 1161
  • Numbers of messages : 6894
  • Numbers of users : 698
  • Numbers of points : 615
Similar topics
I like the tube checker and after using it I noticed the paper rolls that contain the test settings did not wind properly and after a while the right portion of the roll could not be read. So how do you keep the rolls on track and drifting to the right? I
Hey guys, you provably have gotten this message before but i can't find it anywhere else, but Where is the EV checker on HeartGold, or how do you know what EV's does your pokemon have? hope that question makes sense
Greetings to Bob, Kevin, Roy, and other Dynaco Buffs!! First, thanks for creating this forum!! I'm sure I'll be visiting it often with my Dynaco questions, and just for the education. I'd like to ask my first question, and it concerns "bias"
Hi. I just came accross a nice little device I made a number of years ago that's easy to make, and, works well. It's a capacitor checker. It will not properly test electrolytics, but, is good for paper, and, mylar capacitors, as well as mica caps with som
Hello Everyone, around Christmas time I found a Heatkit Mohican in the basement of a house I was helping hauling away junk before they put the place on the market for around $600k Well I would like to get this set up and running and start listening to
Forums from same category
See also
more_less
Informations

2 Replies For the topic :
"Heathkit TC-3 Tube Checker"

This topic has been viewed 1135 times.

Last message :
12/09/2010 at 15h17 by "mikhail7"